Introduction

Avery 500 Fluor Film increases the attention value of short term advertising messages.

Description

• Facefilm: 130 micron, monomerically plasticised vinyl
• Adhesive: semi-permanent, acrylic based
• Backing paper: one side coated bleached kraft paper, 140 g/m2

Conversion

Avery 500 Fluor Films offer excellent conversion properties on a wide range of computerised signmaking equipment.

Features

• Excellent cutting and weeding characteristics.
• “High conspicuity” colours for eye-catching applications.

Recommendations for use

• Short life fluorescent signs, texts and logos.
• Promotional stickers
• High-visibility labels.
• Eye-catching advertising signs and graphics.

PRODUCT CHARACTERISTICS Avery® 500 Fluor Films

Physical properties

Features Test method1 Results

• Caliper, facefilm ISO 534 130 micron
• Tensile strength ISO 1184 1.6 kN/m
• Elongation ISO 1184 130%
• Gloss ISO 2813, 20º 10 %
• Dimensional stability DIN 30646 1 mm. max
• Shelf life stored at 22° C/50-55 % RH 2 years
• Durability2 Vertical exposure up to 3 months

Temperature range

Features Results

• Application temperature Minimum: +10° C
• Service temperature -30° to +100° C

Chemical resistance

Features Test method1 Results

• Humidity resistance 120 hours exposure No effect
• Water resistance 120 hours immersion No effect
• Gasoline resistance 2 hours immersion
  1. Appearance: no change
  2. Adhesion: no change
  3. Colour: no change
• Solvent resistance Applied to aluminium, exposed to No effect oils, greases, aliphatic solvents, motor oils,heptane, kerosene and JP-4 fuel.

Important

Information on physical and chemical characteristics is based upon tests we believe to be reliable. The values listed herein are typical values and are not for use in specifications. They are intended only as a source of information and are given without guarantee and do not constitute a warranty. Purchasers should independently determine, prior to use, the suitability of this material to their specific use.

All technical data are subject to change.

Warranty

Avery® branded materials are manufactured under careful quality control and are warranted to be free from defect in material and workmanship. Any material shown to our satisfaction to be defective at the time of sale will be replaced without charge. Our aggregate liability to the purchaser shall in no circumstances exceed the cost of the defective materials supplied. No salesman, representative or agent is authorised to give any guarantee, warranty, or make any representation contrary to the foregoing.

All Avery® branded materials are sold subject to the above conditions, being part of our standard conditions of sale, a copy of which is available on request.

1. Test methods
   More information about our test methods can be found on our website.
2. Durability
   The durability is based on middle European exposure conditions. Actual performance life will depend on substrate preparation, exposure conditions and maintenance of the marking. For instance, in the case of signs facing south; in areas of long high temperature exposure such as southern European countries; in industrially polluted areas or high altitudes, exterior performance will be decreased.

500_florescent_film_PRODUCT DATA SHEET PDF download